Greenham Catalogue - Edition 23

HAZARD WARNING LAMPS

ROAD DANGER LAMP LEGISLATION • The Traffic Signs Regulations and General Directions 2002 dictated that all road danger lamps must conform to BS EN 12352 and, in other circumstances, BS 3143: Part 2 and Part 4. • On road works where a street lamp is lit within 50 metres of the works and the speed limit is 40 mph or less, road danger lamps must flash at a rate of between 55 and 150 flashes per minute. • On all other works, the rate of flashing should be not less than 900 flashes per minute – i.e. static. • All lamps conform to BS EN 12352. Buying Guide These are essential devices to be used in alerting others to the dangers of roadworks or unexpected obstacles. Our range covers requirements for both motorway traffic management or urban utility. All our lamps featured are manufactured to withstand vigorous outdoor conditions and rough handling. Constructed from tough moulded plastic and all featuring super bright LEDs.

Ledalite Easyfix cone bracket, steady or flashing dual mode. Bi-directional polycarbonate lens. BS3143 and EN12352 compliant. Conelight Contact operated switch. Guaranteed to be switched off when in storage. Photocell as standard. BS3143 part 2 and BS EN12352. Unilamp 360° polycarbonate lens. Steady or flashing. Integral cone bracket. Lightbars Designed specifically for site, services and maintenance vehicle operators. Magnetic, suction, 12V.

Conelight Synchro Can be used in 100 lamp lines, spacing min 2.2m, max 10m, to deploy in any order of sequence. Meets DFT specification for use on motorways and trunk roads on leading tapers. BS3143 and EN12352 compliant. SynchroGuide A powerful uni-directional lamp which can be used in synchronised rows of lights with or without back light. BS3143 and EN12352 compliant. Ecolite 360° polycarbonate lens, barrier fixing bolts supplied.

WARNING LAMPS

DON’T FORGET BATTERIES CODE: 200212

DON’T FORGET BATTERIES CODE: 200212

Dorman ConeLITE Synchro Warning Lamp Meets DFT specification for motorways, trunk roads and lead-in tapers. • Super bright synchronised LED • High impact polycarbonate unidirectional lens with retro-reflective ring • Automatically activated when placed onto a cone, de-activated on removal • Over 100 lamps may be placed in line, spacing minimum 2.2m, maximum 10m • No master or slave • Tough even at low temperatures

ConeLITE Warning Lamp Fits onto cone and houses a single battery. • Tough polyethylene body, Lexan polycarbonate lens • LED light source – greatly reduces running costs • No bolts, keys or cone brackets • Static photocell

Code: 208339

Code: 208336

DON’T FORGET BATTERIES CODE: 200212

DON’T FORGET BATTERIES CODE: 200212

DON’T FORGET BATTERIES CODE: 200212

EcoLITE Warning Lamp 6 Volt unit 360º single battery lamp. • Barrier fixing bolt • Simple battery change

LEDALITE Warning Lamp LED bi-directional single battery lamp. • Mode switch flash/steady operation • Detachable cone bracket • Tough polycarbonate lens and polypropylene body • Flash/steady • Easy battery change (no key required)

UniLAMP Warning Lamp High impact polyethylene single battery casing. • Polycarbonate lens to maximise light output • Integral cone bracket, tie loop and barrier bolt Static photocell

Flashing

Code: 208331

Code: 208308

Flashing Photocell

Flashing photocell

Code: 208334

Code: 208337

Code: 208307

i

Waste electrical and electronic equipment (WEEE) – We fully comply to this directive and facilities are available throughout our Service Centre network for safe disposal of these products.

Ways to order: Online | Phone | Instore

468