Greenham Catalogue - Edition 24

ROAD DANGER LAMP LEGISLATION • The Traffic Signs Regulations and General Directions 2002 dictated that all road danger lamps must conform to BS EN 12352 and, in other circumstances, BS 3143: Part 2 and Part 4. • On road works where a street lamp is lit within 50 metres of the works and the speed limit is 40 mph or less, road danger lamps must flash at a rate of between 55 and 150 flashes per minute. • On all other works, the rate of flashing should be not less than 900 flashes per minute – i.e. static. • All lamps conform to BS EN 12352. These are essential devices to be used in alerting others to the dangers of roadworks or unexpected obstacles. Our range covers requirements for both motorway traffic management or urban utility. All our lamps featured are manufactured to withstand vigorous outdoor conditions and rough handling. Constructed from tough moulded plastic and all featuring super bright LEDs. HAZARD WARNING LAMPS

WARNING LAMPS

DON’T FORGET BATTERIES CODE: 200212

Dorman ConeLITE Synchro Warning Lamp Meets DFT specification for motorways, trunk roads and leading tapers. • Super bright synchronised LED • High impact polycarbonate uni-directional lens with retro-reflective ring • Automatically activated when placed onto a cone, de-activated on removal • Over 100 lamps may be placed in line, spacing minimum 2.2m, maximum 10m • No master or slave • Tough even at low temperatures

DON’T FORGET BATTERIES CODE: 200212

ConeLITE Warning Lamp Fits onto cone and houses a single battery. • Tough polyethylene body, Lexan polycarbonate lens • Contact operated switch • No bolts, keys or cone brackets • Static photocell • BS3142 Part 2 and BS EN12352 compliant

Code: 208339

Code: 208336

DON’T FORGET BATTERIES CODE: 200212

DON’T FORGET BATTERIES CODE: 200212

DON’T FORGET BATTERIES CODE: 200212

EcoLITE Warning Lamp 6 Volt unit 360º single battery lamp. • 360° polycarbonate lens • Barrier fixing bolts supplied • Simple battery change

LEDALITE Warning Lamp LED bi-directional single battery lamp. • Steady/flashing dual mode • Detachable cone bracket • Bi-directional polycarbonate lens • Easyfix cone bracket • Easy battery change (no key required) • BS3143 and EN12352 compliant

UniLAMP Warning Lamp High impact polyethylene single battery casing. • 360° polycarbonate lens to maximise light output • Integral cone bracket, tie loop and barrier bolt Static photocell

Flashing

Code: 208331

Code: 208308

Flashing Photocell

Flashing photocell

Code: 208334

Code: 208337

Code: 208307

i

Waste electrical and electronic equipment (WEEE) – We fully comply to this directive and facilities are available throughout our Service Centre network for safe disposal of these products.

Ways to order: Online | Phone | Instore

464